# Shutdown on wallmount

**URL:** https://forum.onefinitycnc.com/t/shutdown-on-wallmount/13245
**Category:** Troubleshooting (X35/X50)
**Created:** [May 24, 2022, 2:24am UTC](https://forum.onefinitycnc.com/t/shutdown-on-wallmount/13245 "2022-05-24T02:24:13Z")
**Posts on this page:** 1
**Showing post:** 3

<div class="post-metadata">

### Author: ![JimHatch](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/jimhatch/32/3928_2.png) [@JimHatch](https://forum.onefinitycnc.com/u/JimHatch)
#### Post date: [May 24, 2022, 3:05pm UTC](https://forum.onefinitycnc.com/t/shutdown-on-wallmount/13245/3 "2022-05-24T15:05:41Z")

</div>

> [@Nightman](#):
>
> is there a solution to stop the x rail releasing the z rail to fall down to the bottom of the machine.

I use a low-tech method. I cut a couple of pieces of wood that I stick in between the Y rails so when the X drops, it gets held up by the two wooden supports.

I don’t have the 1F vertical table but I have a rotating table top that I keep stored in a vertical position.

---

_[View the full topic](https://forum.onefinitycnc.com/t/shutdown-on-wallmount/13245)._