# Thoughts on my table design?

**URL:** https://forum.onefinitycnc.com/t/thoughts-on-my-table-design/14109
**Category:** Machine Setups
**Created:** [July 13, 2022, 3:30am UTC](https://forum.onefinitycnc.com/t/thoughts-on-my-table-design/14109 "2022-07-13T03:30:39Z")
**Posts on this page:** 1
**Showing post:** 8

<div class="post-metadata">

### Author: ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)
#### Post date: [July 13, 2022, 5:28pm UTC](https://forum.onefinitycnc.com/t/thoughts-on-my-table-design/14109/8 "2022-07-13T17:28:22Z")

</div>

Hey Patrick,

a few thoughts on **tables** for the Onefinity:

- With Lee’s @TDE [Fold Down Wall Mounted CNC Table](https://forum.onefinitycnc.com/t/fold-down-wall-mounted-cnc-table/4783) you can put it into vertical position or [even at any angle inbetween](https://forum.onefinitycnc.com/t/mounting-onefinity-at-a-45/13812/6)

- Jim @JimHatch modified the [Fisher-style table concept](https://fishersshoponline.com/plans/p/fishers-mobile-assembly-table) to accomodate the [48″x32″ Journeyman](https://www.onefinitycnc.com/product-page/onefinity-journeyman) which can be seen here:

- Many people like to clamp workpieces vertically, [as shown here](https://forum.onefinitycnc.com/search?q=clamping%20vertically) and [here](https://forum.onefinitycnc.com/search?q=mounting%20vertically). This would not be possible with such a low table that you show above.

- If you think of an **enclosure** , I find [this concept rather mature](https://forum.onefinitycnc.com/t/the-table-basic/3787/10), see also [here](https://forum.onefinitycnc.com/t/the-table-basic/3787/85) and [here](https://forum.onefinitycnc.com/t/the-table-basic/3787/75) for its integrated dust outlet. I would make it dust-tight and isolated against noise. What this enclosure takes into account and what I find important, is what @cyberreefguru stated in [Cnc Table Hindsight 20/20](https://forum.onefinitycnc.com/t/cnc-table-hindsight-20-20/5965):

> [@Cnc Table Hindsight 20/20](https://forum.onefinitycnc.com/t/cnc-table-hindsight-20-20/5965/2):
>
> To that end, I really wish I could walk around my machine. I only have access from the front and leaning over to get to the back of the machine (clamps, clean, etc.) is quite the pain in the \*\*\*.

- Have you considered [drag chains](https://forum.onefinitycnc.com/search?q=drag%20chains)?

---

_[View the full topic](https://forum.onefinitycnc.com/t/thoughts-on-my-table-design/14109)._