# Tips on keeping drag chains aligned?

**URL:** <https://forum.onefinitycnc.com/t/tips-on-keeping-drag-chains-aligned/39404>\
**Category:** Gen 2 Elite Series\
**Created:** [July 26, 2026, 5:16pm UTC](https://forum.onefinitycnc.com/t/tips-on-keeping-drag-chains-aligned/39404 "2026-07-26T17:16:39Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![melgray](https://avatars.discourse-cdn.com/v4/letter/m/13edae/32.png) [@melgray](https://forum.onefinitycnc.com/u/melgray)\
**Post date:** [July 26, 2026, 5:16pm UTC](https://forum.onefinitycnc.com/t/tips-on-keeping-drag-chains-aligned/39404/1 "2026-07-26T17:16:39Z")

</div>

Hi all,

Having a lot of fun with my new Gen 2 Elite Foreman. Setup was smooth and all test cuts are coming out great.

One slight issue that I haven’t been able to figure out (not a show stopper) - neither of my drag chains want to stay on their rails. Everytime I run a job they both want to come loose and just kind of hang off the side of the gantry. Any tips for keeping them where they’re supposed to be?