# Tool Setter Problems (Solved with link)

**URL:** <https://forum.onefinitycnc.com/t/tool-setter-problems-solved-with-link/24863>\
**Category:** Tool Setter\
**Created:** [January 22, 2024, 9:51pm UTC](https://forum.onefinitycnc.com/t/tool-setter-problems-solved-with-link/24863 "2024-01-22T21:51:48Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![poppyscott](https://avatars.discourse-cdn.com/v4/letter/p/a587f6/32.png) [@poppyscott](https://forum.onefinitycnc.com/u/poppyscott)\
**Post date:** [January 22, 2024, 9:51pm UTC](https://forum.onefinitycnc.com/t/tool-setter-problems-solved-with-link/24863/1 "2024-01-22T21:51:48Z")

</div>

Finally got my Tool Setter yesterday. Installed it today, but it doesn’t seem to act properly. After I home the machine, the gantry then goes and stops above the tool setter (does not probe for z). If I zero at a specific x, y, and z, the gantry moves to above the tool setter but only pauses for a second and then goes to the carve. When I change bits for the next carve, the gantry again moves to above the tool setter, but does not probe for the depth but goes right back to the carve (not knowing a new z depth). Any suggestions?

---

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [January 22, 2024, 9:59pm UTC](https://forum.onefinitycnc.com/t/tool-setter-problems-solved-with-link/24863/2 "2024-01-22T21:59:16Z")

</div>

> [@Eazy-Z Tool Setter Settings Change (if it doesn't move down in Z when commanded)](https://forum.onefinitycnc.com/t/eazy-z-tool-setter-settings-change-if-it-doesnt-move-down-in-z-when-commanded/24422):
>
> The Tool Setter settings in the F1 page should be green/low. If yours is set to red/high, follow the steps below to adjust. Go to the f1 page. [Leave the password blank.](https://forum.onefinitycnc.com/t/what-is-the-password-for-the-masso-controller-faq/20191) Hit enter. Scroll down in the center column. Find Input 11 line labeled “tool setter”. Single tap that line so that it is highlighted. Do not double tap the line. Push the space bar to change it from red/high to green/low. Ensure it is green/low for correct operation. Reboot the machine and try again. …

---

<div class="post-metadata">

**Author:** ![poppyscott](https://avatars.discourse-cdn.com/v4/letter/p/a587f6/32.png) [@poppyscott](https://forum.onefinitycnc.com/u/poppyscott)\
**Post date:** [January 23, 2024, 1:41am UTC](https://forum.onefinitycnc.com/t/tool-setter-problems-solved-with-link/24863/3 "2024-01-23T01:41:34Z")

</div>

Yep! That was it. Thanks