# Toolsetter inaccuracy with Redline **URL:** \ **Category:** Controller (Redline) Discussion\ **Created:** [August 18, 2026, 3:51am UTC](https://forum.onefinitycnc.com/t/toolsetter-inaccuracy-with-redline/39553 "2026-08-18T03:51:41Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![SailorMike](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/sailormike/32/3290_2.png) [@SailorMike](https://forum.onefinitycnc.com/u/SailorMike)\ **Post date:** [August 18, 2026, 7:29pm UTC](https://forum.onefinitycnc.com/t/toolsetter-inaccuracy-with-redline/39553/2 "2026-08-18T19:29:57Z")
Indeed I did. Take a look at this thread. > [@Tool Setter Advice?](https://forum.onefinitycnc.com/t/tool-setter-advice/39479): > > Hello, all; I just got my new Redline Gen 2 upgrade working, and ran my first carve. It was a very simple one, as I wanted to make sure that the tool setter worked as advertised. I’ve read and watched every piece of information I can find on tool setter installation and use. I went through the setup procedure, seemed to go well. I did an XYZ probe and ran my code. First part of the carve was OK. When I got to the first manual tool change, the routine went smoothly, but when the carve resumed, … Also, double-check to make sure that every tool has a unique ID in your CAD tool list, and that it matches the tool ID in the HMI tool list. --- _[View the full topic](https://forum.onefinitycnc.com/t/toolsetter-inaccuracy-with-redline/39553)._