# Transferring Vcarve files not working! **URL:** \ **Category:** Uncategorized\ **Created:** [October 12, 2021, 7:18pm UTC](https://forum.onefinitycnc.com/t/transferring-vcarve-files-not-working/8236 "2021-10-12T19:18:29Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\ **Post date:** [October 12, 2021, 7:53pm UTC](https://forum.onefinitycnc.com/t/transferring-vcarve-files-not-working/8236/2 "2021-10-12T19:53:44Z")
are you sure you’re loading gcode (.nc/.ngc) files and not vectric design(.crv) files? > [@File Format For Loading Files onto a USB stick (Buildbotics)](https://forum.onefinitycnc.com/t/file-format-for-loading-files-onto-a-usb-stick/1725): > > This only applies to the buildbotics controller. If your going to use a usb stick to load your gcode files, make sure your usb stick is either partitioned in the NTSF or FAT32 format. Using any other file type may not show files on the controller. USB sticks must be 2.0. USB 3.0 sticks may not be detected. Some USB sticks larger than 32GB may not work with the raspberry pi. We recommend using a USB stick, 32gb or less. We do not recommend using an SSD. File names must not include the . (d… --- _[View the full topic](https://forum.onefinitycnc.com/t/transferring-vcarve-files-not-working/8236)._