# Ultimate OF X-50 Table Build (From Jay Bates)

**URL:** <https://forum.onefinitycnc.com/t/ultimate-of-x-50-table-build-from-jay-bates/18836>\
**Category:** Accessories\
**Created:** [February 16, 2023, 3:44pm UTC](https://forum.onefinitycnc.com/t/ultimate-of-x-50-table-build-from-jay-bates/18836 "2023-02-16T15:44:34Z")\
**Posts on this page:** 1\
**Showing post:** 17

<div class="post-metadata">

**Author:** ![GrimResistance](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/grimresistance/32/7198_2.png) [@GrimResistance](https://forum.onefinitycnc.com/u/GrimResistance)\
**Post date:** [February 21, 2023, 10:28pm UTC](https://forum.onefinitycnc.com/t/ultimate-of-x-50-table-build-from-jay-bates/18836/17 "2023-02-21T22:28:54Z")

</div>

I’ve found the homing to be more accurately repeatable after adding the stops like shown in this thread [Stops for Homing](https://forum.onefinitycnc.com/t/stops-for-homing/2980)

I’ve not tested how accurate it actually is but I believe it’s better than just using the bearings as stops.

---

_[View the full topic](https://forum.onefinitycnc.com/t/ultimate-of-x-50-table-build-from-jay-bates/18836)._