# V-carve inlay - accuracy?

**URL:** <https://forum.onefinitycnc.com/t/v-carve-inlay-accuracy/35627>\
**Category:** Elite Series (Masso & Redline) (Gen 1)\
**Created:** [October 7, 2025, 3:00am UTC](https://forum.onefinitycnc.com/t/v-carve-inlay-accuracy/35627 "2025-10-07T03:00:28Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![cyberreefguru](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/cyberreefguru/32/27385_2.png) [@cyberreefguru](https://forum.onefinitycnc.com/u/cyberreefguru)\
**Post date:** [October 7, 2025, 3:02pm UTC](https://forum.onefinitycnc.com/t/v-carve-inlay-accuracy/35627/3 "2025-10-07T15:02:49Z")

</div>

Hello Zachariah - are those measurements in inches or mm? Assuming they are inches since you say the cut is 2.5” tall. Frankly, 0.02” is not what I would expect. You should be getting sub-0.005” accuracy. Though it probably matters what you are measuring with - digital calipers?

Have you tested if the machine is [calibrated properly](https://forum.onefinitycnc.com/t/testing-and-tuning-of-for-accuracy/1846/14)? Lots of good suggestions in that thread.

-Tom

---

_[View the full topic](https://forum.onefinitycnc.com/t/v-carve-inlay-accuracy/35627)._