# Vcarve pro and onefinity post processor

**URL:** <https://forum.onefinitycnc.com/t/vcarve-pro-and-onefinity-post-processor/8539>\
**Category:** J Tech Laser\
**Created:** [October 27, 2021, 11:55pm UTC](https://forum.onefinitycnc.com/t/vcarve-pro-and-onefinity-post-processor/8539 "2021-10-27T23:55:57Z")\
**Posts on this page:** 1\
**Showing post:** 6

<div class="post-metadata">

**Author:** ![Dwc](https://avatars.discourse-cdn.com/v4/letter/d/f19dbf/32.png) [@Dwc](https://forum.onefinitycnc.com/u/Dwc)\
**Post date:** [December 29, 2021, 4:29am UTC](https://forum.onefinitycnc.com/t/vcarve-pro-and-onefinity-post-processor/8539/6 "2021-12-29T04:29:45Z")

</div>

> [@Jtech Laser Post Processors for Vectric (Download Links Included) (Old thread, built into Vectric 11.0 and beyond)](https://forum.onefinitycnc.com/t/jtech-laser-post-processors-for-vectric-download-links-included-old-thread-built-into-vectric-11-0-and-beyond/702):
>
> If you are running Vectric 11 or newer, these are built into Vectic and you do not need to download and install these. Updated 6/17/21 Version (2.0): [Onefinity Laser (Inch) V2.pp](https://forum.onefinitycnc.com/uploads/short-url/6cnpPvOqPfRHusTKMgCNLmTBJc1.pp) (4.9 KB) [Onefinity\_Laser\_mm\_V2.pp](https://forum.onefinitycnc.com/uploads/short-url/tprhjAQqsgTR9jCh4JmM5OrAmE5.pp) (4.9 KB) Install these to use the Jtech Laser add on when using Vectric.

---

_[View the full topic](https://forum.onefinitycnc.com/t/vcarve-pro-and-onefinity-post-processor/8539)._