# VCarve Pro settings for rotary?

**URL:** <https://forum.onefinitycnc.com/t/vcarve-pro-settings-for-rotary/32799>\
**Category:** Onefinity Rotary 4th Axis 'The Revolution'\
**Created:** [April 29, 2025, 7:32pm UTC](https://forum.onefinitycnc.com/t/vcarve-pro-settings-for-rotary/32799 "2025-04-29T19:32:49Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![RTJ](https://avatars.discourse-cdn.com/v4/letter/r/ad7895/32.png) [@RTJ](https://forum.onefinitycnc.com/u/RTJ)\
**Post date:** [April 29, 2025, 7:32pm UTC](https://forum.onefinitycnc.com/t/vcarve-pro-settings-for-rotary/32799/1 "2025-04-29T19:32:50Z")

</div>

Are there any changes necessary for VCarve Pro to use the rotary? Do the post-processor settings need modification?

---

<div class="post-metadata">

**Author:** ![Ken5](https://avatars.discourse-cdn.com/v4/letter/k/f0a364/32.png) [@Ken5](https://forum.onefinitycnc.com/u/Ken5)\
**Post date:** [April 29, 2025, 8:05pm UTC](https://forum.onefinitycnc.com/t/vcarve-pro-settings-for-rotary/32799/2 "2025-04-29T20:05:56Z")

</div>

You need to use a wrapped Y or X axis processor depending on the rotary’s position.  
Make sure you have selected rotary job in the V-Carve job setup

---

<div class="post-metadata">

**Author:** ![RTJ](https://avatars.discourse-cdn.com/v4/letter/r/ad7895/32.png) [@RTJ](https://forum.onefinitycnc.com/u/RTJ)\
**Post date:** [May 10, 2025, 4:03pm UTC](https://forum.onefinitycnc.com/t/vcarve-pro-settings-for-rotary/32799/3 "2025-05-10T16:03:02Z")

</div>

![image](https://us1.discourse-cdn.com/flex022/uploads/onefinitycnc/original/3X/f/a/fa250c81737355188b052438696bee03c2aed138.png)  
I updated the post processor management in VCarve Pro and found the rotary post processor for Onfinity Masso.

WrapY2A works with the rotary aligned along the X axis