# VFD to Spindle Cable Length

**URL:** <https://forum.onefinitycnc.com/t/vfd-to-spindle-cable-length/19983>\
**Category:** Spindle/VFD (Aftermarket/Unsupported)\
**Created:** [April 12, 2023, 4:41am UTC](https://forum.onefinitycnc.com/t/vfd-to-spindle-cable-length/19983 "2023-04-12T04:41:34Z")\
**Posts on this page:** 1\
**Showing post:** 9

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [April 27, 2023, 8:07pm UTC](https://forum.onefinitycnc.com/t/vfd-to-spindle-cable-length/19983/9 "2023-04-27T20:07:14Z")

</div>

Hey Andre,

this is a signal cable. For signal cables you usually take shielded 0.14 – 0.75 mm² (AWG 28 to 18). Choose a cable that has an outer diameter that will fit into the strain relief clamp of the connector.

> [@VFD/SPINDLE wiring schematic for Elite Masso machines](https://forum.onefinitycnc.com/t/vfd-spindle-wiring-schematic-for-elite-masso-machines/20022/1):
>
> [VFD wiring on Elite.pdf](https://forum.onefinitycnc.com/uploads/short-url/sn1fAslgjokz458jWAG4NKcdL5k.pdf) (114.1 KB)
> 
> ![Screenshot 2023-04-14 103015](https://us1.discourse-cdn.com/flex022/uploads/onefinitycnc/original/3X/e/4/e4e90c9a6bf0be99430f0964396c54c3f94473fd.png)

#### Further reading

[Spindle Control – Masso Documentation](https://docs.masso.com.au/wiring-and-setup/setup-and-calibration/spindle-control)

---

_[View the full topic](https://forum.onefinitycnc.com/t/vfd-to-spindle-cable-length/19983)._