# WIFI No Connect

**URL:** <https://forum.onefinitycnc.com/t/wifi-no-connect/22210>\
**Category:** Troubleshooting (Elite Series)\
**Created:** [September 3, 2023, 5:05pm UTC](https://forum.onefinitycnc.com/t/wifi-no-connect/22210 "2023-09-03T17:05:12Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![gecraig](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/gecraig/32/25631_2.png) [@gecraig](https://forum.onefinitycnc.com/u/gecraig)\
**Post date:** [September 3, 2023, 5:05pm UTC](https://forum.onefinitycnc.com/t/wifi-no-connect/22210/1 "2023-09-03T17:05:13Z")

</div>

Just set up my Elite Juroneyman and tried to connect the WIFI. It will not content to the WFI extender that is 2 feet away from it. I had an F1 Juroneyman X50 and it connected to the extender by ethernet cable. I can connect to the extender on my phone and it works fine. I also opened the controller and resetted the WIFI card but that did not help. I also tried to enter a static IP address and that did not work. I do not want to set up the elite as a network it has too many issues with how you connect to it. Any suggestions?

---

<div class="post-metadata">

**Author:** ![ChrisS](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/chriss/32/22864_2.png) [@ChrisS](https://forum.onefinitycnc.com/u/ChrisS)\
**Post date:** [September 3, 2023, 7:19pm UTC](https://forum.onefinitycnc.com/t/wifi-no-connect/22210/2 "2023-09-03T19:19:57Z")

</div>

What band is the wifi? 5ghz? If so, that’s your problem. Needs to be 2.4ghz b/g/n.

---

<div class="post-metadata">

**Author:** ![gecraig](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/gecraig/32/25631_2.png) [@gecraig](https://forum.onefinitycnc.com/u/gecraig)\
**Post date:** [September 3, 2023, 9:10pm UTC](https://forum.onefinitycnc.com/t/wifi-no-connect/22210/3 "2023-09-03T21:10:47Z")

</div>

So I found the problem. I left out a Capital letter in the SSID. Thanks for the reply.

---

<div class="post-metadata">

**Author:** ![dnielsen](https://avatars.discourse-cdn.com/v4/letter/d/b9bd4f/32.png) [@dnielsen](https://forum.onefinitycnc.com/u/dnielsen)\
**Post date:** [September 5, 2023, 1:56pm UTC](https://forum.onefinitycnc.com/t/wifi-no-connect/22210/4 "2023-09-05T13:56:28Z")

</div>

…glad you got your controller to recognize WiFi. I’m envious. Mine did too but the connection was unreliable so … hard wired (sigh) but rock solid now. I pretty much just use the connection to transfer G-Code files to the controller.