# Woodworker 32 firmware (solved via link) **URL:** \ **Category:** Original/PRO Series (Buildbotics) (Gen 1)\ **Created:** [August 1, 2024, 9:15pm UTC](https://forum.onefinitycnc.com/t/woodworker-32-firmware-solved-via-link/28113 "2024-08-01T21:15:45Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\ **Post date:** [August 1, 2024, 9:45pm UTC](https://forum.onefinitycnc.com/t/woodworker-32-firmware-solved-via-link/28113/2 "2024-08-01T21:45:38Z")
From the faq that was sent in the support ticket: > [@Installing the Z-20 Heavy Duty Z Slider (configuring the software) (BB Controllers)](https://forum.onefinitycnc.com/t/installing-the-z-20-heavy-duty-z-slider-configuring-the-software/18666): > > After physically installing your new Z-20 z slider, you will now need to change the software to match the new hardware in order for it to work correctly. This FAQ only applies to NON-Elite machines. First, firmware 1.2.1 (or later) must be installed on your controller. Click the blue link below to download the latest firmware 1. After 1.2.1 (or later) is installed from the blue link above, Go to the flyout menu (three horizontal lines in the upper left) 2. Click on “Admin”, “General” … --- _[View the full topic](https://forum.onefinitycnc.com/t/woodworker-32-firmware-solved-via-link/28113)._