# X-35 with 3rd Rail - Wall Mount

**URL:** <https://forum.onefinitycnc.com/t/x-35-with-3rd-rail-wall-mount/6053>\
**Category:** Original/PRO Series (Buildbotics) (Gen 1)\
**Created:** [June 11, 2021, 1:28pm UTC](https://forum.onefinitycnc.com/t/x-35-with-3rd-rail-wall-mount/6053 "2021-06-11T13:28:21Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![TNTahan](https://avatars.discourse-cdn.com/v4/letter/t/fbc32d/32.png) [@TNTahan](https://forum.onefinitycnc.com/u/TNTahan)\
**Post date:** [June 11, 2021, 1:28pm UTC](https://forum.onefinitycnc.com/t/x-35-with-3rd-rail-wall-mount/6053/1 "2021-06-11T13:28:21Z")

</div>

All of the pictures I am seeing of the Woodworker wall mounted look to be with the X50 set up. I know the 50 has a stronger motor and the rails are bigger so it does not require the 3rd rail. But will there be a problem using an X-35 (with stiffy) when it is wall mounted? Has that version been tested in the vertical position or just the X50?

---

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [June 11, 2021, 2:11pm UTC](https://forum.onefinitycnc.com/t/x-35-with-3rd-rail-wall-mount/6053/2 "2021-06-11T14:11:38Z")

</div>

It will be perfectly fine.