# X axis slipping on my wall mounted 1F

**URL:** <https://forum.onefinitycnc.com/t/x-axis-slipping-on-my-wall-mounted-1f/12605>\
**Category:** Uncategorized\
**Created:** [April 20, 2022, 11:51pm UTC](https://forum.onefinitycnc.com/t/x-axis-slipping-on-my-wall-mounted-1f/12605 "2022-04-20T23:51:27Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![le\_sous\_bois](https://avatars.discourse-cdn.com/v4/letter/l/d07c76/32.png) [@le\_sous\_bois](https://forum.onefinitycnc.com/u/le_sous_bois)\
**Post date:** [April 20, 2022, 11:51pm UTC](https://forum.onefinitycnc.com/t/x-axis-slipping-on-my-wall-mounted-1f/12605/1 "2022-04-20T23:51:27Z")

</div>

hello all, is there a way that I can ajust the motor on my X axis to be stronger fighting the gravity?  
2 attemps and two times the X axis looses its path (kind of falling down)…not nice.

thks!

Dany

---

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [April 21, 2022, 1:31am UTC](https://forum.onefinitycnc.com/t/x-axis-slipping-on-my-wall-mounted-1f/12605/2 "2022-04-21T01:31:35Z")

</div>

adjust ‘idle current’ on the x motor up from 1 to 1.5 or 2.

---

<div class="post-metadata">

**Author:** ![le\_sous\_bois](https://avatars.discourse-cdn.com/v4/letter/l/d07c76/32.png) [@le\_sous\_bois](https://forum.onefinitycnc.com/u/le_sous_bois)\
**Post date:** [April 21, 2022, 10:10am UTC](https://forum.onefinitycnc.com/t/x-axis-slipping-on-my-wall-mounted-1f/12605/3 "2022-04-21T10:10:30Z")

</div>

thks, I will try that…