# X Axis Stepper Grinding

**URL:** <https://forum.onefinitycnc.com/t/x-axis-stepper-grinding/23462>\
**Category:** Troubleshooting (X35/X50)\
**Created:** [November 18, 2023, 10:24pm UTC](https://forum.onefinitycnc.com/t/x-axis-stepper-grinding/23462 "2023-11-18T22:24:47Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [November 18, 2023, 10:41pm UTC](https://forum.onefinitycnc.com/t/x-axis-stepper-grinding/23462/4 "2023-11-18T22:41:53Z")

</div>

Hey Tyler,

this is a cable / connector problem. See point 3A in the first link below.

See these Support documents in the [FAQ section](https://forum.onefinitycnc.com/c/faq/23):

- [Troubleshooting: Rail is getting hung, stuck, or out of alignment (x35/x50 machines)](https://forum.onefinitycnc.com/t/troubleshooting-rail-is-getting-hung-stuck-or-out-of-alignment-x35-x50-machines/10826)
- [Axis moving in opposite direction that told to when jogging](https://forum.onefinitycnc.com/t/axis-moving-in-opposite-direction-that-told-to-when-jogging/18379)
- [Support: How to determine if a wire or motor is damaged](https://forum.onefinitycnc.com/t/support-how-to-determine-if-a-wire-or-motor-is-damaged/18446)

---

_[View the full topic](https://forum.onefinitycnc.com/t/x-axis-stepper-grinding/23462)._