# Z Axis Changes During Cut

**URL:** <https://forum.onefinitycnc.com/t/z-axis-changes-during-cut/2266>\
**Category:** Original/PRO Series (Buildbotics) (Gen 1)\
**Created:** [December 23, 2020, 2:07am UTC](https://forum.onefinitycnc.com/t/z-axis-changes-during-cut/2266 "2020-12-23T02:07:03Z")\
**Posts on this page:** 1\
**Showing post:** 6

<div class="post-metadata">

**Author:** ![Dunlow](https://avatars.discourse-cdn.com/v4/letter/d/46a35a/32.png) [@Dunlow](https://forum.onefinitycnc.com/u/Dunlow)\
**Post date:** [December 23, 2020, 4:22pm UTC](https://forum.onefinitycnc.com/t/z-axis-changes-during-cut/2266/6 "2020-12-23T16:22:10Z")

</div>

Can electrical interference cause this? I have the power cable from the router running inside of the coil that holds the z axis stepper motor cable. That was to keep the router power cable up and off of the table.

---

_[View the full topic](https://forum.onefinitycnc.com/t/z-axis-changes-during-cut/2266)._
