# Z axis doing strange things? - SOLVED

**URL:** <https://forum.onefinitycnc.com/t/z-axis-doing-strange-things-solved/14351>\
**Category:** Troubleshooting (X35/X50)\
**Created:** [July 28, 2022, 4:25pm UTC](https://forum.onefinitycnc.com/t/z-axis-doing-strange-things-solved/14351 "2022-07-28T16:25:19Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [July 28, 2022, 4:44pm UTC](https://forum.onefinitycnc.com/t/z-axis-doing-strange-things-solved/14351/2 "2022-07-28T16:44:13Z")

</div>

Hey Adam,

this reminds me of [this](https://forum.onefinitycnc.com/t/was-soo-excited-then-this/13233). The cause of the issue was [this](https://forum.onefinitycnc.com/t/was-soo-excited-then-this/13233/36).

I would check point 3) in [this FAQ document](https://forum.onefinitycnc.com/t/troubleshooting-rail-is-getting-hung-stuck-or-out-of-alignment/10826).

> [@What the heck happened?](https://forum.onefinitycnc.com/t/what-the-heck-happened/14177/3):
>
> The [connectors](https://forum.onefinitycnc.com/t/cable-connectors-used-on-the-onefinity/1886) (not the controller) are the weak spot [on this machine](https://forum.onefinitycnc.com/t/voltage-present/8599/18), especially combined with the [lack of strain relief](https://forum.onefinitycnc.com/t/strain-relief-for-x-gantry-molex-connectors/11461) on this machine. That’s why I would first check what is described [in this FAQ document](https://forum.onefinitycnc.com/t/troubleshooting-rail-is-getting-hung-stuck-or-out-of-alignment/10826/1) under point 3). This is the most common cause of such problems.

---

_[View the full topic](https://forum.onefinitycnc.com/t/z-axis-doing-strange-things-solved/14351)._
