# Z-Axis Erratic - Solved: Inverted XYZ wire **URL:** \ **Category:** Troubleshooting (Elite Series)\ **Created:** [March 21, 2024, 11:35am UTC](https://forum.onefinitycnc.com/t/z-axis-erratic-solved-inverted-xyz-wire/26051 "2024-03-21T11:35:36Z")\ **Posts on this page:** 1\ **Page:** 1
**Author:** ![kpmnd85](https://avatars.discourse-cdn.com/v4/letter/k/76d3ee/32.png) [@kpmnd85](https://forum.onefinitycnc.com/u/kpmnd85)\ **Post date:** [March 21, 2024, 11:35am UTC](https://forum.onefinitycnc.com/t/z-axis-erratic-solved-inverted-xyz-wire/26051/1 "2024-03-21T11:35:36Z")
Here is an exchange I had with Onefinity Tech Support who were very quick to respond and address the issue. I share this as others may be having the same issue due to an inverted XYZ Touch Probe wire. EMAIL EXCHANGE… I have an Elite Foreman. I’m having a problem getting my Z-axis to carve at the correct height. This is particularly when I have a bit change. I have the Easy-Z tool setter but have now disabled it. Here is my process: 1. Turn the machine on Cut down for brevity 7.If the Masso believes there is a different bit in the collet from last carve, it asks me to verify I’ve set the bit up correctly. I push the RUN indicator (green on the screen) a. This is where the machine now seems to reset Z. 1. To recover and continue I execute steps 3-7 above and now the machine carves at the correct depth. I’d appreciate any help. Onefinity Tech Support: The issue you’re describing is something we’ve recently discovered. We’ll need to send a new wire for your XYZ touch probe to correct a grounding issue. Can you please confirm your order number and shipping info for me? Will this also fix the issue with the Easy-Z tool setter? It seems to also have an erratic behavior. Onefinity Tech Support: Yes, it should. They share a common ground, and your probe wire is backwards, so it should fix both. I’ll be getting my corrected wire in a few days. Hope this helps others who may be scratching their heads a bit. Kenric