Easy-Z Tool Setter Problems (what is the proper steps to use it)

[CommunityUser5]

Hey Dean,

you can also use the T command many lines before the M06 command.

@CommunityUser5

T – Select Tool

Tx - prepare to change to tool x.

The tool is not changed until an M6 is programmed.
[…]
On some machines, the carousel will move when a T word is programmed, at the same time machining is occurring. On such machines, programming the T word several lines before a tool change will save time. A common programming practice for such machines is to put the T word for the next tool to be used on the line after a tool change. This maximizes the time available for the carousel to move.

I don’t know if someone in this forum has a cnc mill with tool carousel in their workshop, but I think some already worked on machines with one.