Most likely the spoil board is not flat and/or not coplanar to the machine. In this thread there are many approaches to tramming the machine that could also be used to check for flat and coplanar as well, most require a dial indicator.
Related Topics
Topic | Replies | Views | Activity | |
---|---|---|---|---|
Lines in my spoil board, I trimmed and no go | 4 | 577 | April 23, 2022 | |
Tramming the Router | 119 | 18051 | December 24, 2023 | |
Can I get a little help here? | 7 | 567 | October 25, 2021 | |
Carving out of alignment? | 3 | 696 | January 29, 2022 | |
Machine has a gap on the back side after third setup attempt
|
20 | 925 | July 31, 2023 |