I am only able to set my Woodworker up in a temporary location at this time, but it has allowed me to work on, and test, its functionality and that of my controller.
However, I still wanted the frame supports to be square and co-planer. For the latter, I attached a heavy mass to both ends of a fine fishing line, and hung it over the top tubes on opposite sides (one at very front, one at very back). I did this a second time with a second line in the opposite orientation which then created an ‘X’ in the middle where the lines crossed. I shimmed my supporting base (double 3/4" MDF) until the lines just touched in the middle.
3 Likes