Vacuum platen for my Journeyman. I will do a writeup of the whole build when itās completed. A few coats of sealer and pluming up to the motor and Iām holding work without glue tape or clamps!
The waste board will seal down over this and be consumable.
If I remember correctly, it didnāt take too long. I think it was around 4 or 5 hours with just the finish pass with the tapered ball nose. Sorry about the late reply to your questionā¦
Looks so good!! If youāre on the search for gasket material, Iāve had good luck with All Star CNCās in-board gasketing. The adhesive backed stuff is particularly good for the perimeter where you donāt need to remove it, or for dedicated vacuum fixtures for specific production parts: [https://allstarcnc.com/]
Looks great! Iāll definitely be interested in seeing your complete write up on this build. What vacuum motor/blower is that?
Thanks.
Thanks. Iām running a gasket along the outside edge but will cap the entire platen with a sheet of MDF. The vacuum will pull through the MDF material so I have a flat cutting surface which will also be my spoilboard. If I want to hold small work Iāll sheet plastic the areas not in use to focus hold. Thatās worked in other examples Iāve followed and will mostly work for my case since Iām typically cutting 48x32 sheets.
I found this site had a lot of useful information - ShopBot vacuum motors
Thanks, I thought it might be something like that.
Thanks, looks like lots of good info there.
Thatās where I found and bought my motor. The owner was very helpful about answering questions. Some of the links are not quite what they used to be. The forums and videos were redacted when one of the key partners decided to make vacuum setups for money.
Thatās pretty cool! Did you design this yourself?
I did. This is my design for a 1/9 scale barn. I designed it for one of our neighborās daughters Christmas.
You did an amazing job on those flowers!! 
Was the vase a 3D model that you sliced, or did you design it as all those separate layers? I havenāt seen many projects done this way.
Thanks! Turns out I like flower arranging! Itās 28 pieces of 3/4 plywood cut on the CNC then stacked.
Beautiful and creative. Iāve considered using the CNC to create life sized statues. How did you get the layers of the plywood to smoothly transition from one layer to the next? What software are you using?
When I decided to buy a CNC, this was the āIāll probably never pull it off, but wouldnāt it be cool if I couldā project for me. This is the practice version to work out all the machining quirks.
It looks like you are well on your way then. Did you make the design yourself?
