Adapter ring for DeWalt router with offset

21

The 2 I boxed up and forgot to drop in the mail to you this morning are 50mm, below the now deleted 3mm lip.

22

I had a few minuets to try the shim that mrkrag printed for the DeWalt 611.

20250404_124808
20250404_1248083000×4000 1.76 MB

20250404_124821
20250404_1248213000×4000 2.04 MB

With my duck tape shim the top of the router hit the Z slid at the bearing. This pushed the top of the router forward resulting in the bit tilted back. With a flatting bit installed the front of the bit cut deeper then the back. Running a flatting pass resulted very deep ridges. (Shown in bottom have of the test piece of MDF)

20250404_131547
20250404_1315473000×4000 3.6 MB

23

With the printed shim installed the router cleared the Z slider.

20250404_125946
20250404_1259463000×4000 2.17 MB

20250404_125925
20250404_1259253000×4000 1.88 MB

When running the the flatting pass on the top of the test piece no deep ridges.

mrkrag for the win!!! :smiley:

24

Good to hear!

I made changes between printing the ones you got and sending them. The newest iteration is shorter, rimless and has the slot to the right. There are lines on the top surface to help “clock” it to the mount if you want the offset to be as perpendicular as possible.

20250404_150411
20250404_1504111848×2636 296 KB
image
image885×804 61.7 KB
e2f93735-7c5d-4384-b5a9-33918295e628
e2f93735-7c5d-4384-b5a9-33918295e6281920×887 205 KB

25

the way things are looking i am going to hedge my bets and order one of these. Is that possible? I do not have a 3d printer

26

These are good improvements. I did have to adjust a bit to get the shim to the best spot.