Hey Reginald,
by the way, Load-1 is also available on pin 2 of 25-pin I/O port and Load-2 on pin 1.
This is the standard configuration (no need to edit the configuration):
M7 - Turns ‘Load 1’ on.
M7.1 - Turns ‘Load 1’ off.
M8 - Turns ‘Load 2’ on.
M8.1 - Turns ‘Load 2’ off.
M9 - Turns both ‘Load 1’ and ‘Load 2’ off.[…]
The L1 and L2 outputs can be software controlled through GCode commands. “load-1” becomes active when an M7 GCode command is executed, and becomes inactive when a M7.1 or a M9 GCode command is executed. “load-2” becomes active when an M8 GCode command is executed, and becomes inactive when a M8.1 or a M9 GCode command is executed.
– Source: Buildbotics 1.0 Controller Manual
You can check this by writing these commands into the command input field in the MDI tab on CONTROL page and see the result on the indicators tab.
I don’t know Bard, only Bart.
It is completely bullshit, from beginning to end. You know that…
- …as recently reported deeply in the press, Machine learning bots do hallucinate
- Sandra Wachter, professor and senior researcher in data ethics, artificial intelligence, robotics, algorithms and regulation at the Oxford Internet Institute says, it should not be called “Artificial Intelligence”, but rather “Artificial Stupidity”
Know your sources!