Hey everyone- Order #53 here from Minnesota. I’m excited to use this machine, but I think one of the biggest drawbacks in the design is the lack of cable management. It looks like the z stepper control is a coiled retractile cable, but the router/spindle control and y stepper control cables just …

Greg, Thanks for the information. Looks as if I’ll have a little work to do to get my setup the way I want it. I just ordered from your Etsy site both options. Didn’t get free shipping or a military discount😒

I ordered a Ender III V2 before Thanksgiving. The maching will not boot and Creality is very slow to respond, I finally filed a claim with Paypal. Only after I filed the claim did they get back in touch with me. They gave me some troubleshooting steps. I performed these steps and sent the infor…

As a follow up to my post about the Ender printer I received: I solved the problem. The screw holding in the thermistor was tightened to the point of shorting the wires. The original firmware didn’t know how to deal with it. It wasn’t until I loaded TH3D firmware that I actually received an err…

@OnefinityCNC Hello. I may have missed it, but the link in the post above is for a two pin molex connector. Can you send the link for both sizes of the 4 pin connectors and associated pins? In other words, we need the larger connectors that connect to the motors and the smaller connectors th…

@Ziggy - check out this thread: [image] Cable Connectors Used on the Onefinity (all machines) FAQ Some have asked about the connectors on the Onefinity. Here’s a list of what’s used: Non-elite machines (x-35 and X-50) [Cable Connectors] ELITE MACHINES [elite cab…

Thanks!!! I started to peruse the FAQ section but I didn’t.

I needed to do this anyway, so spent far too many hours today looking for these parts. Generally they are available but I had trouble finding the pins in a reasonable quantity. So I did source some alternatives: Molex 39-01-3045 (black) = Molex 39-01-3042 (white) Amphenol 10127716-04LF (black) =…

where did you find these please

Paul - I ordered from Newark, but DigiKey has some of the parts as does Mouser. Netwark was the only place I could find all of them in one go though. 39-01-3042 39-00-0039 10127716-04LF 43030-0001 I created a BOM spreadsheet - you should be able to upload it and let the website find all the par…

Has anyone else considered drag chains?

Accessories

cyberreefguru (The Guru) December 29, 2020, 4:57pm 127

@Ziggy - check out this thread:

-Tom

Topic		Replies	Views
Sagging Drag Chains Elite Series (Masso & Redline) (Gen 1)	55	3960	December 20, 2023
New member, new Journeyman (drag chains, dust collection, spindle grounding, ...) Original/PRO Series (Buildbotics) (Gen 1)	27	4443	May 4, 2025
Drag Chain and wire gauge Uncategorized	22	4758	January 2, 2022
Cable and Vac Management to start off Accessories	15	4858	February 17, 2023
Journeyman wire management Uncategorized	25	4665	June 23, 2024

Has anyone else considered drag chains?

Related topics