[Trapezoid Square Parallelogram] [Measure diagonal of a square] I’m on day 2 of CNC setup and I just discovered something that I do not recall seeing on this forum so I thought I’d share. I mounted my machine per the instructions in the manual and YouTube video and it seemed to go well. Everythi…

Reviving an old thread, before the foreman gets here. Along the lines of “Machinist” (Bill Blades] the return of the 3-4-5 triangle … but the big boy. I have one of these: (it really is quite handy) Folding Layout Asquare-3’x4’x5’ 90° 3Pcs. - Carpentry Squares - Amazon.com And it claims an accur…

I adopted this approach for squaring the machine with an old pair of calipers now dedicated for this verifying square from time to time. It removes any error induced by the alignment of the feet (twist) or Y rails that are different lengths etc. [Squaring a CNC Gantry Machine with Simple T…

Wait, I was told I wouldn’t need to use math any longer…

Moooooooore math. Always more math.

A two-sided piece was when I figured out I was out of square :grimacing:

While wrestling with how to get my parallelogram X-50 square (and the MANY possible challenges), I think I will attach the feet to aluminum (or possibly wood) plates that can somehow move for adjustment if necessary. I’ll have to figure out how to accomplish that, but I think it’s doable. This will …

Hi @DainBramage1 Not sure if you’ve seen this post of an all aluminum table , but you could use small pieces of this aluminum extrusion or entire rails of it for each Y-rail. Cheers to square and coplanar machines!

I did it out of what I had, which was wood! Works pretty well!

Another thing to consider is it could be a trapezoid or otherwise. See diagram. Left is correct, right is not and can cause Y rails to bind. [Square-vs-Parallelogram-2]

I’m using the older controller and there is no calibration for X and Y. But, if you can calibrate for linear distance then why not just add a calibration routine for squareness too!!! Getting these machines perfectly square is a pain in the BUTT!

Is your router frame a parallelogram? Mine was!

Original/PRO Series (Buildbotics) (Gen 1)

349iq2345 April 24, 2024, 12:23pm 98

Hey CalgaryD,

Machine has a gap on the back side after third setup attempt
How to realign the Y rails (x35/x50 machines)

Topic		Replies	Views
Before you setup your Woodworker.. an alignment guide Original/PRO Series (Buildbotics) (Gen 1)	18	4202	May 7, 2025
Is it possible to tram X/Y squareness with fixed feet? Troubleshooting (X35/X50)	27	4223	January 5, 2022
Journeyman 50" not squared Uncategorized	3	1054	February 15, 2023
Out of square issue Uncategorized	13	1967	August 17, 2025
My Squaring Adventure Troubleshooting (X35/X50)	3	491	June 23, 2024

Is your router frame a parallelogram? Mine was!

Related topics