Jtech air assist auto on/off?

I have a 1F Elite Foreman with PWNcnc VFD / ATC and Jtech 24W laser. I have searched the forums, and have not been able to find any concise info on this topic, so I thought I’d start a fresh thread. Since I have the VFD and use the shop cyclone for dust collection, I’m not using the router or vac ports on the back of the 1F controller. Has anyone successfully used those to automatically start / stop the air pump when using the laser?

Thanks,
Mike

How many amps is that pump?

It’s just an aquarium pump, I believe it’s less than 1 amp.

in that case i believe that you would be ok using either of your outlets. vac or the other