Like many new forums, the excitement and

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Jim,

@JimHatch

@Aiph5u

For being a reader that reads everything, then you overlooked this

Nope. That’s the one I relied on. That’s why I went with 48 instead of 49. But down in the thread you’ll see a picture of @hamdiggity 's table. He said his is 72" wide too and there doesn’t look like room for the controller. Not sure why after building mine, but 66" is fine for anyone who is going to mount the controller underneath.

you are right, hamdiggity’s table does not look like there was room for the controller. But that lets me question whether hamdiggitiy did provide the correct width. Or is it an optical illusion? If yours is 72″ too, does it make the same impression regarding tabletop size? Anyway I was sure since Onefinity in their assembly instructions put the controller on the left of the machine they implied the controller when proposing 72″ for a Journeyman table. Journeyman’s feet are about 60″ between outer corners, so with your 72″ table, you have about 6″ on every side? More 5″ and 7″ because of X stepper?

@OnefinityCNC

with motor, it’s exactly 61 1/4"…and that’s without giving the motor air to breath or the wire that comes off of it room to freely move or hang…