We’ll I’ve tried everything. I’ve re set-up the machine twice and put in all new fastening screws. But it still won’t mill a perfectly square corner. I’d say it mills a line out of square by about one millimeter in 16 inches. All of the bolt have been checked and everything is very tight. What’s nex…

Problem Solved! So I made two changes. I loosened all of the bolts holding down the rails to the QCW frame, used a clamp to insure that the rails at the front were perfectly flush with the QCW and then retightened. I also reset my hold-down system, which was not square to the waste board. I figured…

Out of square issue

Ken5 August 17, 2025, 12:47am 12

Did you check out this post

1 Like

Topic		Replies	Views
Journeyman X50 wont square up	10	1208	July 9, 2023
Journeyman 50" not squared	3	1023	February 15, 2023
Is your router frame a parallelogram? Mine was! Original/PRO Series (Buildbotics) (Gen 1)	104	12834	August 27, 2024
Help please X50 not cutting square! Troubleshooting (X35/X50)	4	819	February 9, 2024
Squaring up the x-50 journeyman machine during elite upgrade Original/PRO Series (Buildbotics) (Gen 1)	2	377	February 29, 2024

Out of square issue

Related topics