Does anyone have a good video or instructions for setting up/using the 4th axis with a Redline controller? It’s been out for a while, just wondering why Onefinity hasn’t published one just yet.
OnefinityCNC
July 27, 2026, 1:54am
2
It’s been in our manual section and youtube for a while:
Ken5
July 27, 2026, 12:47pm
3
Here’s an old post based on my experience with the rotary.
So from the limited knowledge and experience I have with the rotary, these are my recommendations.
Work from the centre of the work piece and add 2 inches to the length to avoid hitting the chuck and tailstock
When using the rounding toolpath gadget, it recommends using centre of the piece but I prefer material surface to prevent taking too much off during the intial passes.
I set my x,y and z positions manually (Eventually I’ll figure out the the touch off probe)
Run an air cut (no bit) for y…
Well ain’t that something. I’ve been searching for it for a while and all that came up was various user videos.
