There is no need to be rude. This is a forum not an English lit class. My typing is awful, but I speak fluent Typo 
Not being rude… just pointing out your illiteracy! Perhaps you might learn something?
No one on this forum is illiterate. Mistakes in typing happen all the time. It is just a shame that you feel the need to point them out.
@Ken5 does your spindle ramp up very fast? I’ve always set my VFD to slowly ramp over 10 seconds. Is that user configurable on your Redline.
It’s the factory setting
I’ve never changed it.
If someone is illiterate, they already know. You’re not teaching anything about literacy. I expect what you are teaching is not what you intended.
Do you tell overweight people that they’re fat? Just for their own good right? How about unattractive people? After all if they know you think they’re unattractive they could improve themselves right?
I’m sure all those people you try to help learn something about themselves are ever so grateful for your comments 
I was merely pointing out to Robert that he needs to look at what he is posting … whenever something is spelt incorrectly a red underline appears under the word to signify a mistake. Obviously he does not re-read his comments before posting otherwise he would have picked up the mistakes and been able to correct them before posting.
Have you never heard the phrase ‘sometimes the truth hurts’ … well in this case it is certainly true.
Off topic - somewhat - but I immediately wondered where you were from when I saw the word ‘spelt’ used instead of “spelled”
I think it is a British vs American English preference with both being accepted and correct.
I am 72 I stopped being hurt by snide and useless Karen comments a long time ago.
Just FYI … I am older than you & paid attention when I was at school and can read & write as well as most people!
Unfortunately, you obviously didn’t and don’t.
Closing the thread to keep the forum focused on CNC, not personal attacks.