Tool Setter Advice?

[SailorMike (Michael Bruck)]

Here’s the solution, courtesy of the good folks at redlinecnc support:

Using the Toolsetter with Redline Controller | Proper Order of Opperations | Quickstart Guide

Using the Toolsetter with Redline Controller | Quickstart Guide If you don’t have a Toolsetter, you can purchase one here: The following steps assume that you have properly installed and enabled the Toolsetter and that you have set a Manual Tool Change location. This @Redlinecnc YouTube video shows how: [How to Set Up the Tool Setter on a CNC Powered by the Redline CNC Controller] When you start your machine, be sure to “Home All” first Verify that the tool number in your spind…