Tool Setter Problems (Solved with link)

Finally got my Tool Setter yesterday. Installed it today, but it doesn’t seem to act properly. After I home the machine, the gantry then goes and stops above the tool setter (does not probe for z). If I zero at a specific x, y, and z, the gantry moves to above the tool setter but only pauses for a second and then goes to the carve. When I change bits for the next carve, the gantry again moves to above the tool setter, but does not probe for the depth but goes right back to the carve (not knowing a new z depth). Any suggestions?

1 Like

Yep! That was it. Thanks