Toolsetter inaccuracy with Redline

[SailorMike (Michael Bruck)]

Indeed I did. Take a look at this thread.

Tool Setter Advice?

Hello, all; I just got my new Redline Gen 2 upgrade working, and ran my first carve. It was a very simple one, as I wanted to make sure that the tool setter worked as advertised. I’ve read and watched every piece of information I can find on tool setter installation and use. I went through the setup procedure, seemed to go well. I did an XYZ probe and ran my code. First part of the carve was OK. When I got to the first manual tool change, the routine went smoothly, but when the carve resumed, …

Also, double-check to make sure that every tool has a unique ID in your CAD tool list, and that it matches the tool ID in the HMI tool list.