Hey Wayne,
Surfacing bits and V-bits are not suitable for probing X and Y with a touch probe block.
Precisely. For probing X and Y, you could also use a bit’s shank. The only thing that matters is that you know its exact diameter (check with sliding caliper) and enter this value into the field that pops up when probing.
See also
Support videos:
- How to Probe a V-Bit on the Onefinity CNC
- Manually Setting X,Y,Z Zero on the Onefinity CNC
- Onefinity Touch Probe Fine Tuning
- Installing the Touch Probe
Accessories