New to lasers and am working through the decision process to buy the Vectric Laser Module or Lightburn. I have read a lot about the two and it seems it’s a 50/50 split. One question continues to come up that I just can’t see to figure out an answer for. Do I need to download a separate post processor for the Vectric Module? For that fact, do I need one for Lightburn? Its a little confusing. Thanks
I can’t speak to Vectric, but no additional download/license is needed for Lightburn for the JTech
1 Like
I have both. However I use Lightburn for most of the laser work. I have been using Aspire for 6 years and am very comfortable using Vectric which is why I purchased the laser module. I use it only when I do a carve and add laser to it afterwards.
1 Like