Z-20 with 80mm Spindle on QCW

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Jim,

this is nothing new:

@Aiph5u

if you switch from the stock 65 mm milling motor mount to the optional 80 mm spindle mount , then the spindle’s shaft center (and subsequently the machine’s entire cutting area) will be located approx. 19/32″ / 15.1 mm more towards front .

This refers to old Z-16 however.

Didn’t know about spindle center moving towards left, and X travel reduced! How does it come?