I just installed the z20 slider on my x50 and the instructions say to change 3 settings. I am going to do that, but the rest of the settings vary drastically from the screen shot in the instructions.

Just do this and it’s two clicks: [image] How To Reset The Configuration To Defaults (BB Controller) Controller (Buildbotics) FAQ Occasionally, there may be a time when you need to reset the machine back to factory defaults. Here’s how to perform a configuration reset. P…

Z20 slider settings

FAQ Z-20 Z Slider

OnefinityCNC (Onefinity Support) November 18, 2023, 8:22pm 2

Just do this and it’s two clicks:

Topic		Replies	Views
How To Reset The Configuration To Defaults (BB Controller) BB (Buildbotics) Default Configuration FAQ	0	8893	January 4, 2021
Z-20 slider and homing Troubleshooting (X35/X50)	3	698	March 24, 2024
Installing the Z-20 Heavy Duty Z Slider (configuring the software) (BB Controllers) Z-20 Z Slider	1	3192	March 16, 2023
New Z-20 Slider Not Stall Homing Properly Troubleshooting (X35/X50)	6	215	December 16, 2024
After upgrading to firmware 1.2 beta: “Z-16 Original” or “Z-20 Heavy Duty”? Firmware (BB Buildbotics)	3	715	February 3, 2023

Z20 slider settings

Related topics