1F cutting weird after updating to 1.0.9

[OnefinityCNC (Onefinity CNC Official ✅)]

Z Axis Moving Unexpectedly (Cutting too shallow or too deep)

Typically, This is one of 3 things: Bit slippage: The bit is not clamped tight enough to stay in and during cutting forces, it moves or falls out of the router. Ensure you clean out the collet before inserting a bit. If you haven’t in a while, take the collet out and use compressed air to clean it and the hole it goes into the router free from dust. It’s possible your collet is worn out as well and needs to be replaced (this is a consumable part). Ensure you use both wrenches to tighten …