1F cutting weird after updating to 1.0.9

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Marcus,

@brooklynbuffalo

I recently upgradef to the 1.0.9 because i bought a jtech 14w laser. And ever since i have had major issues with the machine cutting files in really weird paths, dropping and raising bit randomly during cut and not plunging at the depths set in gcode. Ive ran these files hundreds of times in the past with no issues other than router issues. Hopefully someome can help, as what it is doing is making my end product unusable

the appearance of this issue after upgrading may be just a coincidence. However problems of this kind often appear due to cable connector problems.

@brooklynbuffalo

@Z Axis Moving Unexpectedly (Cutting too shallow or too deep)

Typically, This is one of 3 things: Bit slippage: The bit is not clamped tight enough to stay in and during cutting forces, it moves or falls out of the router. Ensure you clean out the collet before inserting a bit. If you haven’t in a while, take the collet out and use compressed air to clean it and the hole it goes into the router free from dust. It’s possible your collet is worn out as well and needs to be replaced (this is a consumable part). Ensure you use both wrenches to tighten …

I thought this as well. However i installed a new collet after cleaning and it didnt work. So i put a brand new makita router in and its still doing it

Did you check point 2 and especially point 3 mentioned in the link above?