Good day everyone! I recently upgraded to the 80mm spindle mount and installed a spindle. Prior to the install, my Z axis was working perfectly fine. I did have to switch my Y axis so that my controller was on the opposite side. I also reversed the motor direction for the Y axis to accommodate t…

The solution was to reset the configuration. I read through the solution from 1F and that fixed the issue! thank you all for your help!

80mm spindle mount issue (solved in comments)

CommunityUser5 August 29, 2024, 11:08am 3

Hey Jeremiah, hey Jim,

this can be set in ADMIN → General Settings → Configuration in the Controller.

1 Like

Topic		Replies	Views
Installed z-20 motor with brake, pulled “homing error” on first operation	0	86	September 30, 2024
80 mm Spindle Bit Location Onefinity Spindle Kit by Redline CNC	7	269	May 12, 2025
Error code I'm getting Troubleshooting (X35/X50)	4	256	August 15, 2024
Z homing in wrong direction Original/PRO Series (Buildbotics) (Gen 1)	3	262	January 21, 2025
Z 0 Home set to a lower height? Original/PRO Series (Buildbotics) (Gen 1)	0	43	March 12, 2026