"A Man's GOT to Know His Limitations"

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Jim,

@Webb

Here’s what makes it work:

@Webb

PD002=0 ( 1 For 0-10v Terminal Control or Remote Trim Pot Control ) INCORRECT. IT WORKS WHEN SET TO 1

Yes, that’s what I meant above. Potentiometer is not Operator Panel but Analog Terminal. But it’s written here also correctly: “1 For Terminal Control or Remote Trim Pot Control” which means, “not the Operator Keys (0)”

@Webb

PD142=( 220VSet for your motor Amp Rating 1.5Kw Spindle 7 amp ) FOR 1.5kW MOTOR WITH 5 AMP RATING, I HAVE SET THIS VALUE AT 5. IT WORKS AND THE MOTOR STAYS COOL/LUKE WARM.

@Webb

PD70=0 ( This may need to be set to 1 if Control Voltage is 0-5v ) INCORRECT. ON BOARD POTENTIOMETER REQUIRES “1”

Comme Ghislain @blaghislain le dit dans Recommended Huanyang Configuration

@Webb

PD73=120 ( 100 Minimum Setting ) INCORRECT. TO STAY ABOVE THE 8000 RPM MINIMUM THIS IS SET AT 140

Yes, we discussed it above to set the lower limit according to the rated lower limit of the spindle (8,000 rpm).

Jim, I thank you too. The fact that I helped you was not only because I am so helpful but also because I wanted to check whether the translation of my knowledge from the (much better documented) Omron MX2 / Hitachi WJ200 VFD is correct, and because I am collecting the practical knowledge for a Wiki/FAQ entry for the VFD/Spindle Topic. The Huanyang VFD seems by far to be the most-used VFD here.