So my fat head bumped the E-stop while I was attempting the 1.1.1 update. Now after turning it on I get a “Failed to start load kernel modules” and after that the screen goes blank. Any ideas on how to fix?

If the controller won’t boot, you may need to reflash the SD card. [image] How to reflash the operating system on the Onefinity BB controller (Full SD card image) Full SD Image There are times when you may have a file go corrupt or (advanced) users start poking under the hood and may need to reflash the entire vanilla image to the sd card. This process is essentially reinstalling the Onefinity operating system from scratch. This process is only for advanced users OR if you were directed to this via support. If you are looking to update the firmware from a controller that is working properly, do not use this method, look for the update file in the ‘firmware updates’ s…

Thank you, this helped and I’m back up and running.

Accidental E-stop while updating (solved)

Uncategorized

Matticustard September 15, 2022, 11:26pm 2

If the controller won’t boot, you may need to reflash the SD card.

Topic		Replies	Views
Controller won’t boot, error codes Troubleshooting (X35/X50)	1	635	February 1, 2023
Touch Screen going black after rebooting Uncategorized	3	1130	September 11, 2021
OOPS BB problem? Troubleshooting (X35/X50)	13	632	February 14, 2024
Firmware update help Uncategorized	1	1143	October 21, 2021
Onefinity CNC Controller White Screen After Update Won’t Load Interface Original/PRO Series (Buildbotics) (Gen 1)	1	121	January 31, 2025

Accidental E-stop while updating (solved)

Related topics