I’m setting up my Elite Woodworker and am struggling to figure out why my cuts are undersized by about 0.4 mm. Any suggestions on how to debug this? For example, I cut a simple 10 mm wide channel 3 mm deep using a 6.35 mm endmill (1/4"). [image] [image] Possible Source of Error: G-code: Seems OK …

Cuts Undersized by ~ 0.4 mm

RTJ (RTJ) February 23, 2025, 12:27am 13

Sounds like a calibration problem. Here’s a related post: Elite Journeyman Calibration

1 Like