Electrical clips that fit the Masso tool setter

[hooperdup123]

Where can I purchase the electrical clips that fit the Masso control for the tool setter

[Geige (Tom Wert)]

[rscamp (Rob)]

I don’t see the right 2-position connector shell in that list, Tom. It looks more like this one:

Connector Housings Part - 430250200 | Molex

[rscamp (Rob)]

If the above is the right connector shell, tin or gold plated contacts are available for 20-24 AWG. Here’s the Mouser link for bulk quantities of the tin plated version:

https://www.mouser.ca/ProductDetail/538-43030-0007

Note: This post has been edited to replace the gold plated version with the tin plated version for material compatibility

[Geige (Tom Wert)]

HERE THE LINKS, my list was not complete:

Cable Connectors Used on the Onefinity (all machines)

Some have asked about the connectors on the Onefinity. Here’s a list of what’s used: Non-elite machines (x-35 and X-50) [Cable Connectors] ELITE MACHINES [elite cable connectors] ELITE MACHINES CONT: (laser/probe/tool setter) The Connector on The PCB (Back of Masso) Cable Shell (Shell at end of cable) Cable Pin (pins used in the shell) Elite Power connectors https://www.mouser.com/ProductDetail/538-39-01-2025

Should be this one:

Connector Housings Part - 430250200 | Molex

[rscamp (Rob)]

@Geige

HERE THE LINKS, my list was not complete:

Thanks for the confirmation of the connector parts, Tom. I missed that other thread.

I have corrected the female terminal link in post #3 above accordingly. The connector shell and associated contacts are available at both DigiKey and Mouser.

[hooperdup123]

Thank you for all of the information it was very helpful.