Looking to learn from others as I design my table. I ordered the Foreman so the footprint of the machine is 64"x62.6". Requirements: Must contain the entire dimensions of the machine within the table footprint. Must be on a mobile base. Must have a removable section for vertical carve capabiliti…

A few quick questions. Any issues with the Kreg table? Which casters are those? Soource? It looks like you have the QWC on the top. Is that needed or nice to have? Which version, below or above install? Thank you.

Hi there! The Kreg has been solid. I have the QCW stacked on top as my intent is for the following sequence: QCW on top of Kreg (finished) QCW folding to wall ( thread ) Split Kreg in two after buying four more legs and two more shorter span kits and reassembling. Goal here is to regain middle room…

Thanks for the reply. Is it not possible to cut the slats and holes on the CNC? It would seem like that is a perfect application. What am I missing?

[image] Doberman: s it not possible to cut the slats and holes on the CNC? It’s an inception problem if this is your first CNC…

Hello. Are you happy with the aluminum extrusion built table? I was thinking about getting the Kreg 64x64. I see some concern about stability on the forums. Also, do you have a parts list/plan for your built. Looks great.

Hi there, I am happy with what I built, although I would make it even sturdier if I did it over again. Essentially I made a near square (70 x 68 inch) upper and lower frame and connected it with 20 inch vertical pieces. tnutz.com has good prices on the alu extrusion and will pre drill and tap the pa…

What size did you go with, 3030? I am studying how the 8020 aluminum extractions work. How did you design yours? I see that two options are: either cut it yourself (it seems like it requires a special saw or blade) or order them to the exact size. I have SketchUp and Fusion 360. If you have a design…

I went with 1515 (1.5 inch square), but 4040 is similar sized if you prefer metric. I had tnutz cut them to size since i figured they would get them nice and square. I also bought a sawblade for my miter saw that was aluminum compatible, and also a little ryobi cordless bandsaw that worked ok for sh…

Chris, love your table build! When you fold the table do you have to disconnect the MASSO’s wiring etc?

Do you have the over the top QWC? Do you think it is necessary to have the QCW with such a sturdy top? What is the benefit? Thanks

Elite Table Builds

Elite Series (Masso & Redline) (Gen 1)

OnefinityCNC (Onefinity CNC Official ✅) December 26, 2025, 8:16pm 208

Drew made an awesome cart!

Here’s spec sheets for those doing the gen 2: Spec Sheets for Gen 2 Elite Series Models

Topic		Replies	Views
The Table basic Original/PRO Series (Buildbotics) (Gen 1)	145	25901	April 9, 2025
Thoughts on my table design? Machine Setups	24	3466	October 10, 2022
Flip up CNC table Gallery	42	10822	May 11, 2021
CNC platform / table / enclosure Accessories	122	17506	November 3, 2022
Journeyman Table	32	4521	May 24, 2024

Elite Table Builds

Related topics