Homing sensors and two axis alarms are "Low" and inverted "Yes" (solved, had homing set too fast)

[OnefinityCNC (Onefinity Support)]

Ignore the yes’ nos for inverting.

Can you do this:

How To Clear Motor Alarms On Onefinity Elite Masso. FAQ

If you have issue with alarms on the motor or control screen or axis are counting down but not moving, try the following: Special Notes: Before doing anything, ensure you blow out each light sensor. Dust build up can affect the light sensing. Use compressed air and a microfiber towel to clean. Direct sunlight can also affect the light sensors. Ensure no direct sunlight is shining in any of the 4 homing sensors. F1 Settings Clearing. Ensure all axes are away from the homing sensors by 2 o…