I have attempted a video

There have been a few folks interested in my Elite Forman ISO-30 ATC build. I promised videos so here is the first… be kind.

The video talks about runout and why it is important. It then goes on to show the actual runout I am getting.

Let me point out I am not trying to sell anything; these are just my opinions. Could I have bought better gear, absolutely, but this is the gear and cost I could justify.

A link to the video: OneFinity Elite Foreman with CNCDepot IS0-30 ATC spindle … runout acceptance test (youtube.com)

I hope this video adds value.

What else would you like to know about this setup.


Video 2 just went out:

  • Table top construction & mounting
  • ATC rack design and operation