The documentation for Jianken spindle mentioned overload current should be set 120% of the rated current.
What would be correct parameter to set in the Hitachi WJ200? I found 2 parameters related to this - C041(Overload warning level) and b022(Overload Restriction level)
Am I correct that C041 just give a warning, but b022 is restricting operation when current exceeding the value set?
There are also level 2 parameters for both, what would be correct values for level 2?
And what would be the overload protection time in Hitachi settings? b023 (deceleration rate at overload restriction, sec)?